9.1 Basic Specifications
184
Comparator setting Comparator execution mode: HIGH, LOW / REF, %
Upper and lower threshold: 0 to 99999 (Resistance)/ 0 to 999999 (Voltage)
Reference value and tolerance:0 to 99999 (Resistance)/ 0 to 999999
(Voltage)
%: 0.000% to 99.999% (percentage range setting applies to both positive
and negative values)
Comparator judgment beeper: OFF/ HIGH, LOW / IN/ ALL
Operating mode: AUTO/ MANUAL
* Measurement value or statistical 3 (population standard deviation
×
3)
can be set as upper threshold or reference values.
Judgment Judgment result: Hi/ IN/ Lo (resistance and voltage judged independently)
Calculates the logical AND of resistance and voltage judgment results and
outputs a PASS/FAIL judgment (EXT I/O output).
Measurement fault value judgments:
OF Hi judgment
-OF Lo judgment
Measurement fault Not judged (no judgment result)
* The voltage measurement value can be judged as an absolute value.
Comparator
Statistical Calculation
Statistical calculation ON/ OFF/ Clear
Auto-clear after printing statistical data
Calculations Total data counts, Valid data counts, Maximum, Minimum, Mean, Standard
deviation, Population standard deviation and Process capability indices
(Cp and CpK)
Calculations trigger Statistical calculation of measured values initiated by EXT I/O signals, key
or remote command
Measurement Memory and Batch Download Functions
Measurement memory ON/ OFF/ Clear
Memory trigger Up to 400 measurement values can be stored in internal memory by EXT I/
O signals, key or remote command.
Stored measurement values can be batch downloaded by remote com-
mand.
* Data stored in memory cannot be displayed on the instrument.
Measurement value output
function
Outputs measured values via the RS-232C interface upon triggering.
Outputs measured values via the RS-232C or LAN interface upon trigger-
ing. (Only for the BT3561A, BT3562A, and BT3563A)
Key-Lock
Key-lock ON/ OFF
Key operations are disabled when ON.
To Next Page
Loading...
