18
Wireless Communications Function
Using the wireless communications function
1
Connect the Z3210 Wireless Adapter (option) to the instrument.
2
Install GENNECT Cross on your mobile device.
3
Turn on the instrument, and then hold down the HOLD and MAX/MIN keys simultaneously
for 1 s or more.
The wireless communications function is enabled.
ashes: communicating
appears: wireless function on
disappears: wireless function o
4
Launch GENNECT Cross and pair it with the instrument.
• When GENNECT Cross is started for the rst time (when there is no registered instrument), the
Instrument Settings screen appears.
• When the instrument is placed near your mobile device, its connection is registered automatically
on the Instrument Settings screen of GENNECT Cross (up to eight instruments).
• Wait for 5 to 30 s until the connection of the instrument is registered after turning on the
instrument. If the connection of the instrument is not registered after 1 minute has elapsed, restart
GENNECT Cross and the instrument.
To Next Page
Loading...
