9
Hold Function (HOLD)
Hold Function (HOLD)
Manual hold
You can stop the display refresh at any time.
1
Press the HOLD key.
The HOLD key lights up, and the [HOLD] symbol appears on the display.
(To cancel, press the HOLD key again.)
Auto hold
When the measured value becomes stable, the display refresh stops automatically.
1
Hold down the HOLD key for 1 s or more.
The HOLD key lights up, and the [HOLD] symbol blinks on the display.
2
Clamp the instrument around an object to be measured.
When the measured value become stable, the display refresh stops automatically.
When performing the next measurement, remove the instrument from the wire and clamp the
instrument around the object under measurement again.
(To cancel, hold down the HOLD key for 1 s or more.)
To Next Page
Loading...
