Operation Diagnosis
188
9.3
Out-of-band Signaling
Basic Configuration
Release
6.0
07/2010
The device enables you
X to signal changes to the status of the plug-in fan out-of-band (outside the
data flow) via a signal contact (see on page 185 “Monitoring the Device
Status via the Signal Contact“)
X to signal changes to the status of the plug-in fan by sending a trap when
the device status changes
X to detect status changes to the plug-in fan in the Web-based interface on
the system side and
X to query changes to the status of the plug-in fan in the Command Line
Interface.
To Next Page
Loading...
Need help?
General
