Entering the IP Parameters
Basic Configuration
Release
6.0
07/2010
2.2
Entering IP parameters via CLI
35
After entering the IP parameters, you can easily configure the device via the
Web-based interface (see the “Web-based Interface” reference manual).
enable Switch to the Privileged EXEC mode.
network protocol none Deactivate DHCP.
network parms 10.0.1.23
255.255.255.0
Assign the device the IP address 10.0.1.23 and
the netmask 255.255.255.0. You have the option
of also assigning a gateway address.
copy system:running-config
nvram:startup-config
Save the current configuration to the non-volatile
memory.
To Next Page
Loading...
Need help?
General
