18 / 56
Putting fruits and vegetables inside the
drawers helps avoid losing moisture and
prevents flavor from getting into other
foods.
To remove a drawer:
1 Open the refrigerator door all the way.
2 Pull the drawer completely open and
move it slightly toward the compartment
wall, then lift the drawer up and pull it out
of your refrigerator.
Note:
You can move the slider on the crisper box
cover part to control the humidity in
drawers, in order to prevent water
desorption of food in the fruit and
vegetable crisper.
4.3 Using the dispenser to get cold
water
The water dispenser is located at the left
side of the fridge. To get cold water, refer
to the following instructions.
1.Open the left refrigerator door.
2.Position you glass at the suggested
position (about 1.5" / 40mm under the
dispenser), then push the dispenser
button with the glass to get water.
3. After releasing the dispenser button, a
few drops may continue to drip. It's
suggested to hold the glass under water
dispenser for 2~3 seconds.
Note:
Don't push the dispenser button forward
without cup, it may cause water spreading.
Take water frequently or a large amount,
dispensing water may not cool enough.
Please wait until water has been cooled
down.
Do not immediately removing your cup or
glass from the dispenser after dispensing
water you need. You should wait for 2 or 3
seconds to prevent spills.
Water clouding phenomenon
All water provided to the refrigerator flows
through the filter which is an alkaline water
filter. In the filtering process, the pressure
of the water that has flowed out of the filter
is increased, and the water becomes
saturated with oxygen and nitrogen. When
this water flows out into the air, the
pressure plummets and the oxygen and
nitrogen get supersaturated, which results
in gas bubbles. The water may temporarily
look misty or cloudy due to these oxygen
bubbles. After a few seconds, the water
will look clear.
4.4 Changing the water filter
To drink the freshest and cleanest water
from your refrigerator, change the filter on
time.
To change the water filter, follow these
steps:
1. Shut off the water supply. Then turn the
water filter (A) about a 1/4 turn,
counter-clockwise.
To Next Page
Loading...
Need help?
General
