19 / 56
2. Pull the water filter (A) from the filter
holder (B).
Note:
To change the water filter easily, shut off
the water supply valve.
Sometimes, it is hard to disassemble the
water filter because impurities in the water
cause it to stick. If you are having
difficulties, grip the water filter firmly and
pull it out.
When you pull the water filter, a little
water can leak from the opening. This is
normal. To minimize the water leaks, keep
the filter cartridge horizontal when pulling
it.
To prevent overflow, empty the water
filter tray(C) and dry around the filter case.
To insert the new water filter, follow the
directions below.
3. Insert the new filter into the filter holder.
4. Push the filter, and then turn it
clockwise until it locks.
If you have trouble inserting the water
filter because of high water pressure, shut
off the water supply valve.
5. If you turned off the water supply, turn it
back on.
Note:
After turning on the water supply, you
should check the leaks. If leaks occurs,
repeat the step 1,2,3,4,5. If leaks persist,
discontinue use and call you supporting
dealer.
Removing any residual matter inside
the water supply line after installing the
water filter
1.After the water filter is replaced,
dispense 2.5 gallons of water (flush for
approximately 5 minutes) to remove
trapped air and contaminants from the
system.
2. Additional flushing may be required in
some households.
3. Open the refrigerator door and make
sure there are no water leaks coming from
the water filter.
Note:
Be sure to flush the dispenser thoroughly,
otherwise water may drip from the
dispenser. This means that there is still air
in the line.
To Next Page
Loading...
Need help?
General
