Hisun VECTOR 500 - Vehicle Controls and Gauges

Operating the Vehicle
8-5
① Parking brake
■ Accelerator Pedal
The accelerator pedal is used to increase the
engine and vehicle speed. Push down on it for
higher speed.
① Accelerator pedal
STOPPING
■ STOPPING
1. Release the accelerator pedal
2. Step on the brake pedal.
CHECK DURING DRIVING
■ Immediately Stop the Engine if：
 The engine suddenly slows down or
accelerates.
 Unusual noises are suddenly heard.
 Exhaust fumes suddenly become very white.
While driving, check the following items to see if
all parts are functioning normally.
① Fuel gauge
■ Coolant Temperature Gauge
CAUTION:
To avoid personal injury:
 Do not remove radiator cap until coolant
temperature is well below its boiling
point. Then loosen cap slightly to relieve
pressure before removing cap
completely.
1. With the key switch “ON” the temperature
gauge indicates the temperature of the
coolant. White Zone for “cold” and Red zone
for “hot”.
2. If the indicator reaches the Red zone, the
engine coolant is overheated. Check the
vehicle by referring to
“TROUBLESHOOTING” section.