EasyManua.ls Logo

Hisun VECTOR 500 - Component and Safety Checks

Hisun VECTOR 500
65 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Periodic Service
10-6
Parking brake
Checking gauges meter service lamps
1. Inspect the instrument panel for broken
gauges meter and warning lamps.
2. Replace if broken.
Checking head light turn signal light etc
1. Inspect lights for broken bulbs and lenses
2. Replace if broken
Checking seat belt and ROPS
1. Always check condition of seat belt and
ROPS attaching hardware before operating
vehicle.
2. Replace if damaged.
Checking joint boot
1. Check to see if the joint boots are damaged
or not.
2. If the boots are cut crashed or show signs of
deterioration. consult your local dealer.
Joint boot Drive shaft
Checking tire inflation pressure
Though the tire pressure is factory-set to the
prescribed level, it naturally drops slowly in the
course of time, thus check it every day and
inflate as necessary.
tire sizes
inflation pressure
Front: 26x9-12
70kPa (10psi)
Rear: 26x10-12
70kPa (10psi)
EVERY 50 HOURS
Greasing
Apply a small amount of multi-purpose grease
to the following points every 50 hours. If you
operated the vehicle in extremely wet and
muddy conditions lubricate grease fittings more
often.
Parking brake
Parking brake pivotspray type grease

Table of Contents

Related product manuals