① Range gear shift lever pivot (spray type grease )
■ Checking engine start system
CAUTION
TO avoid personal injury
Do not allow anyone near the vehicle while
testing.
If the vehicle does not pass the test, do
not operate the vehicle.
◆ Preparation before testing
1. Place all control levers in the “NEUTRAL”
position.
2. Set the parking brake and stop the engine.
◆ Test gear shift range lever safety switch
1. Sit on the operator’s seat.
2. Shift the range gear shift lever to: “F”, “N” or
REVERSE position.
3. Turn the key to “START” position.
4. The engine must not crank.
5. If it cranks consult your local dealer for this
service.
① Range gear shift lever
■ Checking wheel bolt torque
CAUTION
To avoid personal injury
Never operate vehicle with a loose
wheel bolts.
Any time these bolts are loosened they
should be retightened to the specified
torque.
To Next Page
Loading...
