114
Phenomenon Cases not involving a machine defect
Reference
page
The sound
or image
is unstable
or is output
intermittently.
When LAN, USB TYPE A or USB TYPE B port is
selected, some ports of the output may be missing
due to signal processing delay.
Change the signal or use another port.
24, 53
The computer
connected to the
USB TYPE B port
of the projector
does not start up.
The computer cannot start up in the current hardware
conguration.
Disconnect the USB cable from the computer, then
reconnect it after starting up the computer.
10
RS-232C does
not work.
The SAVING function is working.
Select NORMAL for STANDBY MODE item in the SETUP menu.
52
The COMMUNICATION TYPE for the CONTROL port is
set to NETWORK BRIDGE.
Select OFF for COMMUNICATION TYPE item in the
OPTION - SERVICE - COMMUNICATION menu.
69
Network does
not work
The SAVING function is working.
Select NORMAL for STANDBY MODE item in the SETUP menu.
52
The same network address is set for both wireless and wired
LAN.
Change the network address setting for wireless or wired
LAN.
–
NETWORK
BRIDGE
function does
not work
The NETWORK BRIDGE function is turned off.
Select NETWORK BRIDGE for COMMUNICATION TYPE
item in the OPTION - SERVICE - COMMUNICATION menu.
69
Schedule function
does not work
The SAVING function is working.
Select NORMAL for STANDBY MODE item in the SETUP menu.
52
The internal clock has been reset.
When you do not install the battery, once you turn off the
projector in the SAVING mode or the AC power, the current
date and time setting is reset. Check the DATE AND TIME
setting for WIRELESS SETUP or WIRED SETUP in the
NETWORK menu or install the batteries.
–
Troubleshooting
Phenomena that may be easy to be mistaken for machine defects (continued)
(continued on next page)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
