1.
Press POSITION button on the remote control when no menu is indicated.
The “POSITION” indication will appear on the screen.
Adjusting the position
2.
Use the ▲/▼/◄/► cursor buttons to adjust the picture
position.
When you want to reset the operation, press RESET
button on the remote control during the operation.
To complete this operation, press POSITION button again. Even if you do not do
anything, the dialog will automatically disappear after a few seconds.
1.
Press AUTO button on the remote control.
Pressing this button performs the following.
Using the automatic adjustment feature
For a computer signal
The vertical position, the horizontal position and the
horizontal phase will be automatically adjusted.
Make sure that the application window is set to its
maximum size prior to attempting to use this feature. A dark picture may still be
incorrectly adjusted. Use a bright picture when adjusting.
For a video signal and s-video signal
The video format best suited for the respective input signal will be selected
automatically. This function is available only when the AUTO is selected for
the VIDEO FORMAT item in the INPUT menu (
49).
The vertical position and
horizontal position will be automatically set to the default.
For a component video signal
The vertical position and horizontal position will be automatically set to the default.
The horizontal phase will be automatically adjusted.
AUTO
button
POSITION
button
• The automatic adjustment operation requires approx. 10 seconds. Also
please note that it may not function correctly with some input.
• When this function is performed for a video signal, a certain extra such as a line
may appear outside a picture.
• When this function is performed for a computer signal, a black frame may be
displayed on the edge of the screen, depending on the computer model.
•
The items adjusted by this function may vary when the FINE or DISABLE is selected
for the AUTO ADJUST item of the SERVICE item in the OPTION menu (
67).
NOTE
• When this function is performed on a video signal or an s-video signal,
some image such as an extra-line may appear at outside of the picture.
• When this function is performed on a video signal or s-video signal, the range of
this adjustment depends on OVER SCAN in IMAGE menu (
46) setting. It is not
possible to adjust when OVER SCAN is set to 10.
• If POSITION button is pressed when a menu is indicated on screen, the displayed
picture does not move its position but the menu does.
•
This function is unavailable for a signal from the LAN, USB TYPE A / B or HDMI 1 / 2 port.
NOTE
To Next Page
Loading...
Need help?
General
Weight and Dimensions
