OPTION menu
OPTION menu
From the OPTION menu, items shown in the table
below can be performed.
Select an item using the ▲/▼ cursor buttons, and
press the ► cursor button or ENTER button to execute
the item, except for the items LAMP TIME and FILTER
TIME. Then perform it according to the following table.
Item Description
SOURCE SKIP
The ports can be set to be ignored in searching by the AUTO
SEARCH function (
below) or in selecting by buttons on the control
panel.
(1) Choose a picture input port using the
▲/▼ buttons.
(2) Using the ◄/►buttons turns on/off the
SOURCE SKIP function.
NORMAL
ó
SKIP
The port that is set to SKIP will be ignored.
• It's not possible to set SKIP to all ports at the same time.
AUTO SEARCH
Using the ▲/▼ buttons turns on/off the automatic signal search
function.
ON
ó
OFF
When the ON is selected, detecting no signal automatically cycles
through input ports in the following order. The search is started from
the current port. Then when an input is found, the projector will stop
searching and display the image.
COMPUTER IN1
ð
COMPUTER IN2
ð
LAN
ð
USB TYPE A
VIDEO
USB TYPE B
S-VIDEO
COMPONENT
HDMI 2
HDMI 1
• It may take several seconds to project the images from the
USB TYPE B port.
AUTO
KEYSTONE
Using the ▲/▼ buttons turns on/off the automatic keystone function.
ON
ó
OFF
ON: Automatic keystone distortion correction will be executed
whenever changing the slant of the projector.
OFF: This function is disabled. Please execute the AUTO
KEYSTONE (EXECUTE) in the SETUP menu for automatic
keystone distortion correction.
• When the projector is suspended from the ceiling this feature will
not function properly so select the OFF.
• This function will be unavailable when the Transition Detector is on
(
88).
(continued on next page)
To Next Page
Loading...
