Hitachi DZ-GX5080A - AVJ2-L;AVJ3-L Circuit Board; FRT2-L;FRT3-L Circuit Board, Microphone and Front Case

5 - 15
Disassembly and Reassembly > Disassembly
(16) AVJ2-L/AVJ3-L Circuit Board
Fig. 5-3-16
1) Remove the AVJ2-L/AVJ3-L circuit board (a)
from the FRT2-L/FRT3-L circuit board (b) in
the direction of the arrow.
2) Remove the two screws [G].
3) Remove the ground plate (c) in the direction
of the arrow.
4) Remove the AVJ2-L/AVJ3-L circuit board
from the jack holder (d) in the direction of the
arrow.
Caution during disassembly and reassembly:
When assembling the AVJ2-L/AVJ3-L circuit
board and ground plate, tab both onto the
claws of jack holder.
(17) FRT2-L/FRT3-L Circuit Board,
Microphone and Front Case
1) Disconnect the microphone (b) from the
FRT2-L/FRT3-L circuit board (a).
2) With DZ-GX5080A , remove the two screws
[G].
With DZ-GX5020A/GX5000A , remove the
screw [G].
3) Remove the FRT2-L/FRT3-L circuit board in
the direction of the arrow.
4) Remove the microphone in the direction of
the arrow.
[G] M1.7×4 (Silver)
2) [G]
4)
3)
(b)
(c)
(a)
(d)
1)
(c)
(a)
TA B
TA B
(d)
Fig. 5-3-17
4)
3)
1)
(c)
(a)
(b)
1)
[G] M1.7×4 (Silver)
2) [G]
2) [G]
[GX5080A]
(a) FRT2-L/FRT3-L
circuit board
(b) Microphone
(c) Front case
(a) AVJ2-L/AVJ3-L circuit board
(b) FRT2-L/FRT3-L circuit board
(c) Ground plate
(d) Jack holder