Hitachi HDS721050CLA362 - Page 200

HITACHI Deskstar & CinemaStar 7K1000.B & Deskstar E7K1000 Hard Disk Drive specification
196
Device returns command aborted for a second non-volatile Set Max Address command until next power on or
hardware reset.
Device returns command aborted during Set Max Locked mode or Set Max Frozen mode.
After a successful command completion, Identify Device response words (61:60) shall reflect the maximum
address set with this command.
If the 48-bit Address feature set is supported, the value placed in Identify Device response words (103:100) shall
be the same as the value placed in words (61:60). However, if the device contains greater than 268,435,455
sectors, the capacity addressable with 28-bit commands, and the address requested is 268,435,455, the max
address shall be changed to the native maximum address, the value placed in words (61:60) shall be
268,435,455 and the value placed in words (103:100) shall be the native maximum address.
If a host protected area has been established by a Set Max Address Ext command, the device shall return
command aborted.
Output Parameters To The Device
B
Option bit for selection whether nonvolatile or volatile. B=0 is volatile condition. When
B=1, MAX Address which is set by Set Max Address command is preserved by POR.
When B=0, MAX Address which is set by Set Max Address command will be lost by
POR. B=1 is not valid when the device is in Address Offset mode.
Sector Number
In LBA mode, this register contains LBA bits 0 – 7 which is to be input.(L=1)
In CHS mode, this register is ignored. (L=0)
Cylinder High/Low
In LBA mode, this register contains LBA bits 8 – 15 (Low), 16 – 23 (High) which is to be
set. (L=1)
In CHS mode, this register contains cylinder number which is to be set.(L=0)
H
In LBA mode, this register contains LBA bits 24 – 27 which is to be set.(L=1)
In CHS mode, this register is ignored. (L=0)
Input Parameters From The Device
Sector Number
In LBA mode, this register contains max LBA bits 0 – 7 which is set.(L=1)
In CHS mode, this register contains max sector number (= 63). (L=0)
Cylinder High/Low
In LBA mode, this register contains max LBA bits 8 – 15 (Low), 16 – 23 (High) which is
set. (L=1)
In CHS mode, this register contains max cylinder number which is set. (L=0)
H
In LBA mode, this register contains max LBA bits 24 – 27 which is set. (L=1)
In CHS mode, this register contains max head number.(L=0)