EasyManua.ls Logo

Hitachi HDS721050CLA362 - Page 217

Hitachi HDS721050CLA362
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
HITACHI Deskstar & CinemaStar 7K1000.B & Deskstar E7K1000 Hard Disk Drive specification
213
11.42.2.4 Self-test execution status
Bit
Definition
0-3
Percent Self-test remaining
An approximation of the percent of the self-test routine remaining until completion in ten percent
increments. Valid values are 0 through 9.
4-7
Current Self-test execution status
0
The self-test routine completed without error or has never been run
1
The self-test routine aborted by the host
2
The self-test routine interrupted by the host with a hard or soft reset
3
The device was unable to complete the self-test routine due to a fatal error or unknown test error
4
The self-test routine completed with unknown element failure
5
The self-test routine completed with electrical element failure
6
The self-test routine completed with servo element failure
7
The self-test routine completed with read element failure
15
The self-test routine in progress
11.42.2.5 Total Time in Seconds to Complete Off-line Data Collection Activity
This field tells the host how many seconds the device requires completing the off-line data collection activity.
11.42.2.6 Off-Line Data Collection Capability
Bit
Definition
0
Execute Off-line Immediate implemented bit
0
SMART Execute Off-line Immediate subcommand is not implemented
1
SMART Execute Off-line Immediate subcommand is implemented
1
Enable/disable Automatic Off-line implemented bit
0
SMART Enable/disable Automatic Off-line subcommand is not implemented
1
SMART Enable/disable Automatic Off-line subcommand is implemented
2
abort/restart off-line by host bit
0
The device will suspend off-line data collection activity after an interrupting command and
resume it after some vendor specific event
1
The device will abort off-line data collection activity upon receipt of a new command
3
Off-line Read Scanning implemented bit
0
The device does not support Off-line Read Scanning
1
The device supports Off-line Read Scanning
4
Self-test implemented bit
0
Self-test routine is not implemented
1
Self-test routine is implemented
5-7
Reserved (0)
6
Selective self-test implemented bit
0
Selective self-test routine is not implemented
1
Selective self-test routine is implemented

Table of Contents

Related product manuals