Hitachi IJ RX2-SD160 - 4.13.3 Skip specified character and print (Count skip) (Continued)

●Use the count function 4-70
Count conditions 2015.07.0712:45
Com=0
[Stop ]
Message name[ ]
Column1
Item2
Back
《 》
110 20
1st screen
3rd screen2nd screen
Count blocks:1/1
ＣＣＣ
ー
＋
M
Manual
Startup
Apply
HOME
Increment
Jump from:
to:
Reset
Count skip
・・・
・・・
・・・
01
down
up
Direction
Ⅰ Ｑ ・ ・ ・
ＡＡＡ ＡＡＢ ＡＡＣ ‥‥ ＡＡＨ ＡＡＪ
ＡＡＫ ＡＡＬ ＡＡＭ ‥‥ ＡＡＰ ＡＡＲ
ＡＡＳ ＡＡＴ ＡＡＵ ‥‥ ＡＨＺ ＡＪＡ
ＡＪＢ ＡＪＣ ＡＪＤ ‥‥ ＨＺＺ ＪＡＡ
ＪＡＢ ＪＡＣ ＪＡＤ ‥‥ ＺＺＹ ＺＺＺ
Press 2nd screen and switch Count conditions screen.
Input "I" and "Q" at "Count skip" on the 2nd screen of Count conditions.
5
Count conditions
screen switching
Count skip
Skip the characters inputted to "Count skip", then print the next count value.
See the figure below for print example.
6
● When the "Count character" is added, overwritten or deleted, the confirmation
message "Changed skip condition" shows up on the screen and "Count skip"
character becomes invalid.
● As to Range (maximum), input either one kind of capital alphabetical character, small
alphabetical character or user pattern.
In addition, all "Count skip" characters must be included in the smallest range.
● Characters which were set as Value, Range, Jump or Reset cannot be input to "Count
skip".
● When the "Count skip" is set, the incremental value is 1=fixed.
Precautions when using count skip printing