Hitachi IJ RX2-SD160 - 9.2.2 Warning messages

●On-screen message descriptions 9-7
No. Message Meaning of message Remedy
61
Makeup Self Life
information
Replacement of makeup is recommended.
● Use makeup within its
expiration date at
eplacement.
●Confirm makeup lot number
on unit information screen.
● Contact your nearest local
distributor.
62
Internal
Communication
Error C
The internal data processing error.
● Ink stop and the printer power
OFF are recommend.
Turn the printer OFF and then
back ON after 10 seconds.
63
Internal
Communication
Error M
The internal data processing error.
● Ink stop and the printer power
OFF are recommend.
Turn the printer OFF and then
back ON after 10 seconds.
9.2.2 Warning messages
No. Message Meaning of message Remedy
65
Excitation V-ref.
Review
The excitation voltage reference needs to
be updated.
● Perform the Nozzle test and
update the Excitation V-ref.
setting.
( Technical manual 6.10)
66
Viscosity Reading
Instable
The viscometer output readings fluctuated.
Setting will be temporarily switched to no
use of viscometer.
● Contact your nearest local
distributor.
67
Viscosity
Readings Out of
Range
The viscometer is defective.
Setting will be temporarily switched to no
use of viscometer.
● Contact your nearest local
distributor.
68 Ink Viscosity High The ink viscosity is above the proper level.
● The ink concentration will be
adjusted to normal level.
If print quality is still poor,
then replace ink.
( Technical manual 6.3)
69 Ink Viscosity Low Ink viscosity is below the proper level.
● The ink concentration will be
adjusted to normal level.
If print quality is still poor,
then replace ink.
( Technical manual 6.3)
71 Battery Low M
The internal battery in engine section is
low.
The latest print data and operating
information may not be saved.
● Contact your nearest local
distributor.
● Replace the internal battery
in engine section and set the
data/time. ( 6.2).
72
Calendar Content
Inaccurate
Calendar content is inaccurate due to mal-
function of the clock.
● Contact your nearest local
distributor.
● Set the date/time. ( 6.2).
-
External
Communication
Error nnn
The serial communication port had a date
error.
● Note the error code and see
that no more errors occur.
( Technical manual 5.7)