9-4 ●On-screen message descriptions
No. Message Meaning of message Remedy
14
Charge Voltage
Too Low
The charging voltage supplied to the nozzle
drive board EZJ125 from the high-voltage
power supply unit is too low.
● Contact your nearest local
distributor.
15
Charge Voltage
Fault
The charge electrode signal is faulty.
● Check that there is no short-
circuit with another part.
16
No Ink Drop
Charge
The ink drops are not electrically charged.
● Check if the ink stream is at
about the center of the gutter.
● Clean the gutter, deflection
electrode, and its
surroundings.
● Adjust the excitation V-ref. to
make sure that the ink drops
are well made.
( Technical manual 6.11).
● Check the ink pressure.
( Technical manual 6.10).
17
Ink Heating Unit
Temperature
Sensor Fault
The temperature measured at the ink
heating unit is out of normal range.
The heater will be temporarily deactivated.
● Contact your nearest local
distributor.
18 Memory Fault C The memory data has a fault. ● Execute system setup.
19 Memory Fault op
The memory of the option board EZJ130
has a fault.
● Contact your nearest local
distributor.
20 Memory Fault M The memory data has a fault.
● Contact your nearest local
distributor.
21
Ink Drop Charge
Error
Charge control on ink drops has a fault.
No print or disordered print may occurs.
● Contact your nearest local
distributor.
22
Internal
Communication
Error S
The internal data processing error.
● Turn the power OFF and then
back ON after 10 seconds.
23
System Operation
Error S
Unexpected error occurred.
Please verify if the work is printed
correctly.
● Afer ink is stopped, turn OFF
the power of the printer.
● Contact your nearest local
distributor
24
Ink Heating
Unit Over Current
The ink heating element is shorted.
The heater will be temporarily deactivated.
● Contact your nearest local
distributor.
25
Ambient
Temperature
Sensor Fault
The ambient temperature measurement is
out of normal range.
●
Contact your nearest local
distributor.
26
Print Controller
Cooling Fan Fault
The cooling fan of the print controller area
is faulty.
● Contact your nearest local
distributor.
30 Memory Fault S The memory data has a fault.
● Contact your nearest local
distributor.
31 Pump Motor Fault Pump motor is faulty.
● Contact your nearest local
distributor.
32
Inside Temperature
Sensor Fault
The inside temperature measurement is out
of normal range.
● Contact your nearest local
distributor.
34
Ink Heating Unit
Temperature Low
The ink heater in the print head is unable to
heat the ink enough to reach the correct
operating temperature.
The heater will be temporarily deactivated.
● Contact your nearest local
distributor.
To Next Page
Loading...
