●On-screen message descriptions 9-5
(2) Faults that do not invoke ink stoppage
No. Message Meaning of message Remedy
35 Model-key fault Model-key recognition failed.
● Contact your nearest local
distributor.
37 Language key fault Language-key recognition failed.
● Contact your nearest local
distributor.
No. Message Meaning of message Remedy
35 Model-key fault Model-key recognition failed.
● Contact your nearest local
distributor.
37 Language key fault Language-key recognition failed.
● Contact your nearest local
distributor.
27
Print Data
Changeover
Error C
The print data change procedure was
incomplete.
● Check the data entered
28
Print Data
Changeover
Error M
The print data change procedure was
incomplete.
● Check the data entered
38
Free Layout
Printing Failure
The free layout printing was aborted while
the message was printing.
● Delete some print items or
decrease the setting of the ink
drop use. ( 4.8.6)
40
External
Communication
Error nnn
The serial communication port had a data
error.
● Note the error code and see
that no more error occure.
( Technical manual 5.7)
42
Ink Drop Charge
Too High
The charge sensor detects a high drop
charge.
● Clean the gutter, deflection
electrode, and its
surroundings.
● Adjust the excitation V-ref. to
make sure that the ink drops
are well made.
( Technical manual 6.11)
● Adjust the ink pressure.
● Check that the ink stream is
correctly retracted.
( Technical manual 6.10)
43
Barcode Short On
Numbers
The number of characters for the selected
barcode type is insufficient.
●Configure the number of
( 4.8.5) characters for
barcode to appropriate value.
( Technical manual 9)
44 Shutdown Fault The shutdown process failed.
●Turn the printer power OFF by
main switch.
Contact your nearest local
distributor.
45 Count Overflow
The calculation result of the count
multiplier overflowed.
● Change the count multiplier
setting.
46
Invalid Data
Change Timing
A print operation was requested while the
print data was being changed.
● Change of either data change
or print start.
47
Invalid Count Data
Change Timing
A print operation was requested while the
print data was being changed.
● Change of either data change
or print start.
48
Invalid Print S
tart
Timing
The print target detection signal for the next
target arrived during the data was being
changed.
● Change of either data change
or print start.
To Next Page
Loading...
