Hitachi PJ-TX200W - Air Filter

58
Maintenance
(4) Select the “LAMP TIME” item in the right column of the Advanced Menu
using the ▲/▼ cursor buttons, then press the ► cursor button and the
LAMP TIME menu will appear.
(5) Pressing the ▲ cursor button in the menu resets the LAMP TIME.
• Only reset the LAMP TIME item when you have replaced the lamp so
that the LAMP TIME remains accurate.
NOTE
Air filter
If the air filter becomes clogged by dust or the like, internal temperatures will
rise and could cause fire, burn and/or projector malfunction. When the indicators
or a message prompts you to clean the air filter, make sure to clean it as soon
as possible. Check and clean the air filter periodically, even if no message is
displayed.
Please replace the air filter when it is damaged or too dirty to be cleaned.
Preparation of a new air filter is recommended. To purchase a new air filter,
contact your dealer and tell the air filter type number =
NJ22632.
Replace the air filter when the lamp is replaced. An air filter of the specified type
will be included with replacement lamps for this projector.
1.
Turn the projector off, and unplug the power
cord. Allow the projector to sufficiently cool
down.
2.
After making sure that the projector has
cooled adequately, remove the filter cover
and air filter. Hold the knobs while lifting.
3.
Use a vacuum cleaner to clean the air filter
vent, the air filter and filter cover.
Please replace the air filter when it is
damaged or too dirty to be cleaned.
4.
Set the cleaned or new air filter into place, and press the point between the 2
knobs.
5.
Turn the projector on (20).
Filter
cover
Knobs
Knobs
Air filter