Language Setting
When turning the power supply ON for the rst time, the language setting screen is displayed after a few minutes.
Select the language for operation and tap “Set”.
Adjusting Date/Time
After setting the language, the screen for adjusting date and time screen is displayed on the touchscreen as shown in the
gure.
Tap “Set” on the touchscreen display, and set the date and time following the indicated procedure.
Refer to the Adjusting Date/Time section in the Menu chapter for detailed information.
NOTE
Setting the date and time may be required after a prolonged power failure. If “Set Date/Time” is displayed on the screen in such a case,
then tap “Set” to adjust the date and time.
Set Date/Time
Set
5 Centralised remote controls
PSC-A32MN
TCGB0106 rev.0 - 12/2014
302
To Next Page
Loading...
