128
MAINTENANCE
1.6 Removing Electrical Box
(1) Remove the service cover.
(2) Remove the upper cover.
(3) Remove the securing screws for electrical box.
Tool Phillips Screwdriver
Model: 3~3.5HP
Note:
Remove the electrical box after disconnecting wires.
(1) Remove the 4-Way valve coil, the expansion valve coil, and the solenoid valve coil.
(2) Disconnect the fasten terminals from high pressure switch and pressure sensor.
(3) Disconnect the fan motor connectors and thermistors from the outdoor unit PCB.
(4) Disconnect the compressor wires and loosen all cord clamps.
(5) When mounting the electrical box, join and t the electrical box and the partition plate into the outdoor
unit.
●
Remove the electrical box from the top of outdoor unit.
To Next Page
Loading...
