68
(5) Cause Code of Comp. Inverter Stoppage ( )
Code
(SEG1)
Cause
Corresponding of
Cause Code of I.D.
Stoppage
Remark
Indication during Retry Alarm Code
IPM Error
Instantaneous Overcurrent
Inverter Fin Thermistor Protection Activation
Electronic Thermal Protection
Inverter Voltage Decrease
Overvoltage
Abnormal Communication --
Abnormal Current Detection
Instantaneous Power Failure Detection -- --
Reset of Micro-Computer for Inverter -- --
Ground Fault Detection from Compressor
Open Phase Detection -- --
Inverter Malfunction
Communication Error
Protection Device Actuation (PSH) -- --
Abnormal Protective Device -- --
Early Return Protective Device -- --
Step-Out Detection -- --
Abnormal PCB Setup -- --
EERPOM Error -- --
Abnormal Comp. Frequency
Beyond Frequency Scope
DC BUS Pre-charge Malfunction -- --
Phase Default of Comp. Inverter Output
Overcurrent of L1 Reactor
Overcurrent of L2 Reactor
Overcurrent of Comp. Inverter Input
Overload of Comp. Inverter Input
Error of IPM Temp. Sensor
TROUBLESHOOTING
To Next Page
Loading...
