¿ Hood dimensions (field supplied)
•
The following figures show the recommended dimensions of the air inlet and outlet hoods for the outdoor unit.
• Use 1 mm thick steel plates for the hoods and 1.5 mm for the brackets.
• Use drilled steel plates for the air inlet hoods.
• Paint the hoods in accordance with Munsell code 1.0Y 8.5/0.5 beige color.
• Use self-tapping screws M5 for fixing the hoods.
• Reinforce the hoods with brackets if necessary.
• All measurements are in mm.
RAS-(8-12)FSXN
No. Name
1 Air discharge hood
2 Rear suction hood
3 Left suction hood
4 Right suction hood
5 Safety cable (to prevent overturning)
6 Air flow direction (front side)
7 Air flow direction (rear side)
2 Unit installation
15
SMGB0065 rev. 1 - 12/2010
2
To Next Page
Loading...
