Hitachi RPK-1.0FSNSM3 - Operation Lock (PC-ARF); Menu Operation (PC-ARF); Timer Setting Method (PC-LH3 B)

P5415078-rev.3
19
NOTE:
Do not press “RUN/STOP” switch repeatedly
(within 3 seconds). If the switch is pressed
frequently, the wireless remote control switch
may not work correctly.
NOTES:
● The automatic cooling/heating operation
requires other setting separately. Contact
your distributor and contractor for details.
● When the “MODE” switch is pressed at
“AUTO”, the fan operation is started.
(2) Point the transmitter towards the receiver
and press “RUN/STOP” switch.
When the transmitting indicator “
“
ashes, the RUN indicator (orange) on
indoor unit is turned ON and the beep sound
is heard. The operation is started.
< Temperature, Fan Speed and
Air Flow Direction Setting >
To set the temperature, fan speed and air
ow direction, refer to the item 6 “Setting
Method”.
< Stop Operation >
(3) Point the transmitter towards the receiver
and press “RUN/STOP” switch again.
The RUN indicator (orange) of indoor unit is
turned OFF and the beep sound is heard.
The operation is stopped.
The indications of setting temperature,
fan speed and air ow angle are
turned OFF.
NOTE:
After the heating operation is stopped, the
fan mode may be operated for approximately
2 minutes.
NOTE
< Function >
●
This function is used to start or stop the unit
operation at the setting time.
●
The timer setting is available for ON TIMER and
OFF TIMER.
ON TIMER:
The operation is started beyond the set time.
OFF TIMER:
The operation is stopped beyond the set time.
(1) Press “ON TIME” or “OFF TIME” switch.
By repeatedly pressing “ON TIME” or “OFF
TIME”, the indication of setting time is
changed.
The setting time is available at half hour
intervals up to 10 hours and at one hour
interval up to 23 hours after 10 hours.
(2) Point the transmitter towards the receiver
and press “SET” switch.
When the transmitting indicator “
“
ashes, the TIMER indicator (green) on
indoor unit is turned ON and the beep sound
is heard. The timer setting is completed.
8. Operation Lock (PC-ARF)
Refer to the operation manual for PC-ARF.
9. Menu Operation (PC-ARF)
Refer to the operation manual for PC-ARF.
10. Timer Setting Method (PC-LH3B)
When the wireless remote control switch is utilized,
the beep sound for receipt conrmation is heard
from the indoor unit.
AUTO
Beep
RUN
(1.0 and 1.5HP)(2.0 to 4.0HP)
RUN
The figure shows for 2.0 to 4.0HP.
Flashing
The setting time for “ON TIMER”
is set to 6 hours.
COOL
ON
TIMER
Stop
Flashing
COOL
ON
TIMER