Hitachi RPK-1.0FSNSM3 - Contact DStrButor

30
P5415078-rev.3
Trouble Action before Contact
The protection devices (fuse, breaker, ELB, etc) are
frequently activated or the main power source switch does
not work.
Turn OFF the power source.
Water Leakage from Indoor Unit. Stop the operation.
< PC-ARF >
l
The RUN indicator (red) is ashing.
l
The indoor unit number, the alarm code, the unit model
code and the number of connected indoor units are
displayed on LCD.
l
In case that the plural indoor units are connected to
one remote control switch, the above abnormality
informations for each indoor unit are displayed one by
one.
Check the details on LCD and contact your distributor.
Refer the alarm code table.
Contact your distributor and inform the indication
detail on the remote control switch.
<PC-LH3B >
In the case of the wireless remote control switch PC-LH3B,
the alarm codes are indicated by the number of times the
indicator on indoor unit ashes.
Inform the following items to a distributor.
1) Unit Model
2) Content of Trouble
3) Alarm Code No. on LCD or Detail of Flashing Indicator
(Refer to the item 12.2.2 “Abnormality” for details.)
18.3 Contact Distributor
If the trouble still remains even after checking previous items or other troubles not mentioned in the previous
items occur, stop using the product and contact your distributor or contractor.
If abnormality (burnt odor, etc.) occurs, stop the operation and turn OFF the main power source
immediately.
Ifnot,itmaycausebreakageoftheproduct,anelectricshockorare.
Contact your distributor or contractor.
SEL. OP MODE
I.U. : RCI-3.0FSN3
MODEL : b .02
Alarm Code:
22
Indoor Unit Number
O.U. : RAS-3HVRNM2
01-02
ALM RST
ADDR
ENT.
OK