Hitachi RX2

●On-screen message descriptions 9-5
(2) Faults that do not invoke ink stoppage
No. Message Meaning of message Remedy
27
Print Data
Changeover
Error C
The print data change procedure was
incomplete.
● Check the data entered
28
Print Data
Changeover
Error M
The print data change procedure was
incomplete.
● Check the data entered
38
Free Layout
Printing Failure
The free layout printing was aborted while
the message was printing.
● Delete some print items or
decrease the setting of the ink
drop use. ( 4.8.6)
40
External
Communication
Error nnn
The serial communication port had a data
error.
● Note the error code and see
that no more error occure.
( Technical manual 5.7)
42
Ink Drop Charge
Too High
The charge sensor detects a high drop
charge.
● Clean the gutter, deflection
electrode, and its
surroundings.
● Adjust the excitation V-ref. to
make sure that the ink drops
are well made.
( Technical manual 6.11)
● Adjust the ink pressure.
● Check that the ink stream is
correctly retracted.
( Technical manual 6.10)
43
Barcode Short On
Numbers
The number of characters for the selected
barcode type is insufficient.
●Configure the number of
( 4.8.5) characters for
barcode to appropriate value.
( Technical manual 9)
44 Shutdown Fault The shutdown process failed.
●Turn the printer power OFF by
main switch.
Contact your nearest local
distributor.
45 Count Overflow
The calculation result of the count
multiplier overflowed.
● Change the count multiplier
setting.
46
Invalid Data
Change Timing
A print operation was requested while the
print data was being changed.
● Change of either data change
or print start.
47
Invalid Count Data
Change Timing
A print operation was requested while the
print data was being changed.
● Change of either data change
or print start.
48
Invalid Print Start
Timing
The print target detection signal for the next
target arrived during the data was being
changed.
● Change of either data change
or print start.
49 Print Overlap Fault
The print target detecter signal for the next
tar
get arrived during the print operation for
the current target.
● Increase the spacing between
products.
● If the target signal is
chattering, use sensor filter
setting. ( 4.14.1).
50
Print Head Cover
Open
The print head cover is open.
● Remove the cover and then
hit the Clear key.
● If a magnetic substance is
used to fix the cover,
it must be replaced with
nonmagnetic resin (metal).