Hitachi RX2

9-6 ●On-screen message descriptions
No. Message Meaning of message Remedy
51
Detector Position
Improper
The print target detecter signal turned OFF
before print start during printing at repeat
print setting.
● Move the print target detecter
closer to the print head.
● If the target signal is
chattering, use sensor filter
setting.
● Check the data entered.
52
Target Sensor Time
Out
The print target detecter signal was ON
longer than the timeout setting of Target
Sensor Timer.
● If the target is stopped in front
of the sensor, move the target.
● Change the Target Sensor
Timer setting.
( 4.14.1).
53
Target Spacing Too
Close
There are 5 or more print target detector
signal turned ON before print start during
printing at No repeat print setting.
● Move the print target detecter
closer to the print head.
54
Print Data
Changeover In
Progress S
A print operation was requested while the
print data was being changed.
● If the target signal is
chattering, Use Sensor filter
setting.
● Change of timing either print
data change or print start.
55
Ink Self Life
information
Replacement of ink is recommended.
● Use ink within its expiration
dae at replacement.
● Confirm ink of number on
unit information screen.
● Contact your nearest local
distributor.
56 Blank Print Items The print items are not properly set up. ● Change the print data.
57
Excessive Format
Count
A column has more than 8 print format
types (the number of lines, line spacing,
character size, character spacing, bold
charcter and bar code).
● Perform setup so that the
number of print format types
does not exceed 8.
58
Print Data
Changeover In
Progress M
A print operation was requested while the
print data was being changed.
● Change timing of either print
data change or print start.
59
Print Data
Changeover In
Progress V
A print operation was requested while the
video data was being changed.
● Adjust either the encoder
frequency or the pulse rate
division factor.
● Change timing of either print
data change or print start.
60
Communication
Buffer Fault
The print contents are not in the
communication buffer.
.● Adjust the print
and
communication timing.
61
Makeup Self Life
information
Replacement of makeup is recommended.
● Use makeup within its
expiration date at
eplacement.
●Confirm makeup lot number
on unit information screen.
● Contact your nearest local
distributor.
62
Internal
Communication
Error C
The internal data processing error.
● Ink stop and the printer power
OFF are recommend.
Turn the printer OFF and then
back ON after 10 seconds.