Hitachi VM-E535LE User Manual

ENGLISH
LCD MONITOR
When using the LCD monitor during recording and playback, you can adjust the brightness of its screen
and the angle of the monitor.
■ Opening the LCD monitor
1. Press the OPEN button to open the LCD moni¬
tor.
■ Adjusting the brightness of the LCD screen
NOTE: Even when the picture on the LCD moni¬
tor is adjusted, the recorded video will not
change.
1. Load the battery (Refer to "POWER
SOURCES" on page 11). Press the red button
on the CAM/OFF/VIDEO switch as you slide it
to CAM or VIDEO.
2. Use the bright control on the side of the LCD
monitor to adjust the brightness of the LCD
screen.
■ Range in which the LCD monitor can be
moved
■ Cautions on LCD monitor screen
• Do not touch the LCD screen with your fingers
as the screen could get dirty and the picture
will not be seen clearly. If the LCD screen
becomes dirty, use a soft cloth to wipe off the
dirt.
• If the camera/recorder is used in a cold place
and becomes too cold, the LCD screen will be
dim for a while after the power is turned on.
When the temperature inside the camera/
recorder rises, the brightness of the picture
will become normal.
• Do not hold by the LCD monitor as this could
cause a malfunction.
• Open the LCD monitor by 90° before changing
its direction. If you were to attempt to invert
its direction before opening it completely, it
could cause a malfunction.
• The LCD monitor cannot be closed if it is tilted.
• Close the LCD monitor after making sure it is
parallel with the camera/recorder. If you were
to close the monitor while it faces the same
direction as the lens or it is diagonal, it could
damage the LCD monitor.
• Do not disassemble the LCD monitor as this
might cause a malfunction.
• When opening the LCD monitor, be careful
that no water droplets adhere the monitor
screen and that no water or dust enters the
camcorder through the gap as it could cause a
malfunction.

Hitachi VM-E535LE Specifications

General

Brand	Hitachi
Model	VM-E535LE
Category	Camcorder
Language	English