Hitachi VM-E535LE User Manual

ENGLISH
■ Programming the remote control for the VCR
It is necessary to programme the edit remote control code to match the VCR before starting editing.
1. Turn the VCR on.
2. Aim the remote control at the infrared receiver
on the VCR and press the VCR SET button on
the remote control and hold it, then press the
button corresponding to the VCR's maker
code. For example, if you have a PHILIPS VCR,
press the VCR SET button and hold it, then
press the II button. To check whether the
remote control code matches that of your VCR
or not, point the remote control at the infrared
receiver on the VCR and press the VCR SET
button and hold it. If the remote control code
has been set, the VCR channel is counted up
automatically.
NOTES:
• Your VCR should have an infrared remote con¬
trol.
• If the channel on the VCR does not change
with the above operation, you need to switch
the remote control code of your VCR. Refer to
the VCR's instruction manual. If the channel
still does not change after you have changed
the VCR's remote control code, the edit remote
control cannot operate your VCR.
• The remote control code is held in memory
until it is changed or the batteries are replaced.
VCR maker Press VCR SET and the following button
HITACHI
REVERSE
SONY
PROGRAM
Panasonic
FORWARD
TOSHIBA IN
MITSUBISHI
COPY START
SANYO
OUT
SHARP
◄◄
NEC
►
JVC
►►
AKAI
A/VDUB
Gold Star ■
PHILIPS
II
LOEWE
DISPLAY
Grundig
COUNTER RESET
THOMSON
TITLE ON/OFF
• When the edit remote control is connected to
the camera/recorder, the buttons marked * in
the figure above perform the same operations
as those of the other remote control provided.
■ Operation
You can select up to four different scenes or segments to be copied at one time.
39

Hitachi VM-E535LE Specifications

General

Brand	Hitachi
Model	VM-E535LE
Category	Camcorder
Language	English