3. General data
TCGB0075 rev.0 - 11/2012
66
3.6.4 Domestic Hot Water Tank - Electrical heater
Model Power supply
Applicable voltage
IPT (kW) RNC (A)
U max.
(V)
U min.
(V)
DHWS195S-2.0H1E
1~ 230V 50Hz 253 207 2.0 8.7
DHWS260S-2.0H1E
N O T E
(*1): If it is desired to enable the DHW tank heater operation during normal indoor unit operation, adjust the
DSW4 pin 1 of the PCB1 to the ON position and use these protections: CB=40A for single phase (1~) or CB=25A
for three phase (3N~).
D A N G E R
Never connect the DHW tank to the main power supply. Always connect it to the YUTAKI S80 indoor unit as ex-
plained in its Installation and operation manual.