HITEC X1 Pro - Re-Peak Mode

32
NICD/NIMH - DISCHARGE MODE (cont.)
Toggle and hold the joysick to the right (►) for three seconds to
begin discharging.
Once disharging has commenced, the charger
will display the following real-time informa-
tion: battery type, discharging current, battery voltage, discharging
time and discharged capactiy.
Once discharging is complete, the screen will read “
[DISCHARGE
FINISHED]
” and the charger will emit a chiming sound. Toggle left
(◄) once to stop discharging. You may toggle left (◄) at any time
during the discharging process to stop discharging.
NiMH 1.0A 5.96V
DSC 001:43 00030
NICD/NIMH  REPEAK MODE
In Re-Peak Charge mode, the charger can automatically peak
charge the battery 1-3 times consecutively. This is good for
conrming that the battery is fully charged and for checking how
well the battery receives fast charges. A ve minute cool-o delay
occurs after each re-peak charge.
BEFORE YOU BEGIN CHARGING YOUR BATTERY,
MAKE SURE YOU HAVE READ AND UNDERSTAND
ALL OF THE WARNINGS AND SAFETY INFORMATION
CONTAINED ON PAGES 49.
Select the correct battery type by following
the instructions on page 29. Once you have
set the correct battery type, toggle up (▲) or down (▼) until you
see the “
NiMH RE-PEAK” screen.
Toggle right (►) once and the number of re-peak cycles will begin
ashing. Toggle up (▲) or down (▼) to change the number of re-
peak cycles you want the X1 Pro to execute. The X1 Pro can re-peak
NiMH RE-PEAK
1
Warning