User Manual Safety Instructions
EM1 Series AC Servo Motors EM1-01-0-EN-2110-MA Page 13 of 72
Motor can be stored for up to two years indoor with the following conditions:
– Dry
– Dust-free
– No vibration
– Good ventilation
– Resistance to extreme weather
– Indoor air does not contain corrosive gas
– Prevent motor vibration and moisture
If no dry storage environment is available, the following measures need to be taken:
– Wrap the motor with moisture-absorbing material, and then seal the motor.
– Put desiccant in the sealed package; the desiccant needs to be checked and replaced if
necessary.
Check the motor regularly.
Table 3.3: Storage Conditions
Environmental parameter Unit Value
Air temperature
(°C)
-15 ~ 70
Relative humidity (%) 20 ~ 80
Rate of change of temperature
(°C/min)
0,5
Air pressure kPa 70 ~ 106
Condensation - Not allowed
Formation of ice - Not allowed
Store the motor in an environment with good protection. (indoor/factory)
3.3.2.3 Transportation
Attention! Risk of Personal Injury or Damage to Property.
Follow the precautions of AC servo motor transport conditions:
Carefully move the products to avoid damage.
Do not apply excessive force to the product.
Do not stack the products to avoid collapse.
Transport conditions must comply with EN 60721-3-1 (Refer to Table 3.4)
Table 3.4: Transportation Conditions
Environmental parameter Unit Value
Air Temperature (°C) -15 ~ 70
Relative Humidity (%) 20 ~ 80
Rate of Change of Temperature
(°C/min)
0,5
Condensation - Not allowed
Formation of Ice - Not allowed
Transport the motor in an environment with good protection. (indoor/factory)
To Next Page
Loading...
Need help?
General
