14
Speed-Team Operation
Speed team operation is used during high-volume times. An order
taker wearing a Communicator relays orders from outside into the
store, using button A1, A2 or B.
Speed teams are not used in tandem drive-thrus.
Wired Backup System
In order to use a wired backup system, you must have a Switcher
Board (optional) in your base station.
To find out if you have a Switcher Board:
Open the base station as follows.
⎯ Unscrew and remove the remote antenna cable from the top of
the base station.
⎯ Press down on the two release tabs on top of the cabinet and
carefully pull its front panel forward and down.
CAUTION: Do not let the front panel of the base station drop.
Look for the Switcher Board shown in Figure 10. If there is no
Switcher Board, it will not be possible to use a wired backup
system.
If there is a Switcher Board, place the S2 switch in the IN position
to use the wired backup system. When using the Wireless IQ
system, the S2 switch must be in the OUT position.
Close the base station and reconnect the remote antenna cable.
Figure 10. S2 switch on Switcher Board
To Next Page
Loading...