22
FCC NOTICE
This device complies with Part 15 of the FCC rules. Operation is
subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause
harmful interference to radio communication. Operation of this
equipment in a residential area is likely to cause harmful
interference, in which case the user will be required to correct the
interference at his own expense.
Changes or modifications not expressly approved by HM
Electronics, Inc. could void the users authority to operate this
equipment.
The antenna(s) used for the base transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
This device has been designed to operate with the antennas or antenna
kits listed below, and having a maximum gain of 2dBi. Antennas/Kits not
incluced in this list or having a gain greater than 2dBi are strictly prohibited
for use with this device. The required antenna impedance is 50 ohms.
1. Antenna: NEARSON, S181TR-2450R, 2dBi
2. Antenna Kit: HME, EC20 (P/N G28493-1), 0dBi
The term “IC:” before the certification/registration number only signifies
that the Industry Canada technical specifications were met.
Hereby, HM Electronics, Inc. declares that the Wireless IQ System is in
compliance with the essential requirements and other relevant provisions
of R&TTE Directive 1999/5/EC.
This product operates in the 2400 to 2483.5 MHz frequency
range. The use of this frequency range is not yet harmonized
between all countries. Some countries may restrict the use of a
portion of this band or impose other restriction relating to power
level or use. You should contact your Spectrum authority to
determine possible restrictions.
To Next Page
Loading...