13
Using the Count-Down Mode (Timed Mixing)
1. Turn the SPEED dial to select a mix speed.
a. If the count-up mode was used for the previous batch, the desired time
needs to be entered.
b. If the countdown mode was used for the previous batch, the previous time
will be displayed. If a different time is needed, turn the TIME selector to the
desired time.
2. Press the START button to begin mixing; the timer start counting down from the
set time.
a) To stop the mixer at any time, press the STOP button. To resume mixing,
press the START button. For example: the mixer is start at SPEED 1 for 30
seconds and is stopped after 10 seconds. Pressing the START button will
resume the mixing operation.
b) If the mixer is stopped and a new time setting is entered, pressing the START
button saves the new time setting on the current speed selection. For
example: The mixer is started at SPEED 1 for 30 seconds and is stopped after
10 seconds. Turning the TIME selector enters a new time. The new time will
replace the initial 30 seconds for SPEED 1 after the START button is pressed.
c) If the time is changed while mixing, the mixer will operate until the new time
expires. The adjustment to the time will not be stored.
d) If speed is changed while mixing, the time will change to the previous time for
the selected speed and count down.
Note: If the wire cage is opened at any time, the mixing operation will stop. To
resume the mixing operation, close the wire cage and press the START button.
3. When the timer reached 00:00, the mixer stops; a beeper sounds for 3 seconds.
The countdown timer displays the last-entered time.
To Next Page
Loading...
Need help?
General
