Hobby optima - Page 107

Electrical Installations
07-23
Operation via ancillary battery
Position of the 92 Ah/95 Ah AGM ancillary battery
(model-specic)
Theancillarybatteryismountedinthefrontpassenger
console.Thefootofthebatteryisattachedtoabaseplate.
Thepassengerseatincludingtherotatingassemblymustbe
dismantledinordertosubsequentlytorchangethebatteries.
Thebatterysensorissafeguardedbymeansofa10A
fuse.
•Onlyaccumulatorbatterieswithboundelectrolytes(gel
batteries)maybeinstalledinthosepositionsspecied
by the manufacturer.
•Theinstalledgelbatterymaynotbeopened.
•Whenchangingancillarybatteries,useonlybatteries
ofthesamemakeandcapacity.
•Alloftheelectricaldevicesmustbeswitchedobe-
fore you disconnect or connect the ancillary battery.
•Beforereplacingfusesyoumustrstde-energisethe
charger.
•Beforereplacingfusesyoumustrst de-energisethe
charge controller.
•Beforereplacingablownfuseyoumustrstxwhate-
ver caused the fuse to blow.
•Fusesmayonlybereplacedbyfuseswiththesame
fuseprotectionvalue.
•Airingthechargecontrollerinsucientlywillcausea
reduction of the charge current.
•Thesurfaceofthechargercasingmaybecomehot
whenthedeviceisinoperation.