9. Gas130
• Open the ap of the gas bottle container.
• Close the main stop valve on the gas cylinder. Pay attenti-
on to the direction of the arrow.
• Unscrew the gas pressure regulator/ high-pressure hose*
by hand from the gas bottle (left-handed thread).
• Loosen the xing strap and remove the gas cylinder.
• Replace the full gas cylinder in the gas bottle cabinet and
carefully fasten it using the xing straps.
• Screw the gas pressure regulator/ high-pressure hose* by
hand on to the gas bottle (left-handed thread).
• Only when equipped with a crash sensor
*
:
Press on the hose rupture protection (green button) on the
high-pressure hose (p. 132).
• Check that gas is not escaping from the connection point
using leak detector spray.
• Close the door of the gas bottle container.
Do not smoke or ignite open ames while changing the gas
cylinders. After changing the gas bottles, check whether
there is any gas escaping from the tie-in point by spraying it
with leak detection spray.
Changing gas cylinders
Gasshutovalvesandvalves
A corresponding gas stop valve has been built in for each gas
device that has been installed. These gas taps can be used to
interrupt the ow of gas to each device. Each tap has been la-
belled with an icon for the corresponding device.
Placeofinstallationofgasshutovalves
- Refrigerator and cooker: in the top drawer in the
kitchen unit.
- Heating system: in the gas bottle container.
Refrigerator Cooker Heating
To Next Page