10. Built-in devices136
Chapter 10: Built-in devices
10.1 General Information
In this chapter, you will nd information on the devices that
have been built into the van. This information refers only to
the operation of these devices. To some extent, the devices
described are special accessories. For further information on
the individual built-in devices, please refer to the separate ope-
rating instructions that have been included in the blue service
bag found in the vehicle.
10.2 Hot-air heating
Please also refer to the instructions in Chapter 9 for opera-
ting gas devices, gas regulators and gas bottles.
Please observe the instructions in Chapter 7 for operating
electrical devices.
Built-in devices may only be repaired by specialists.
Only the device manufacturer's original spare parts may be
used for maintenance and repair work.
Any changes to the built-in devices as well as non-compliance
with the rules for use will cause the guarantee to become
void and lead to the exclusion of liability claims. Furthermore,
the operating licence for the device will become void and, in
some countries, this means that the operating licence for the
vehicle is also void.
The change to the iNet-ready version was carried out during
the current season. Depending on when the mvan was ma-
nufactured, iNet-ready functions are available, whereby the
Truma CP plus control panel functions as an interface for
operating connected devices via the Truma App and iNet Box.
The combined LPG heating consists of a warm air heater
with an integrated hot water boiler (capacity: 10 l).
You are not permitted to operate the heating system while
driving!
Exception:
As an optional feature, the vehicle can be equipped with a
gas pressure regulator for use while driving (e.g. Control CS).
Truma-Heating
To Next Page
Loading...
