Hobby Van Vantana 2016 - Page 80

7. Electrical Installations
79
Manually calibrating the sensor
Openingthe battery circuitbreakerswitches o the electro-
nicsin the superstructure (see item: battery circuit breaker).
Nowthesensorcancalibrateitself.Thisprocesstakesapprox.
threehours.Ifthebatterycircuitbreakeristhenswitchedon
again,avalueof“1”shouldbeshownonthedisplay.
Charger (charging the battery)
Battery is charged when the charger is con-
nectedtothe 230Vmains.Theintegratedfan
is activated.
Batteryischargedviathegenerator.Motorhas
been started. Battery charger is not activated.
Duringcalibration,thevehiclemustnotbehookedupto
the230Vmains(thechargermustnotchargethebattery
duringcalibration).Furthermore,thevehiclemustnotbe
started while the sensor for the starter battery is being
calibrated.
Battery is charged when the charger is con-
nectedtothe230Vmains.Theintegratedfan
is deactivated.
Error messages
12:30 23,5 ° C
09.01. 15
18,0 ° C
Warning message: undervoltage
This warning appears when a voltage of 10.8V or less is
measuredforabatteryforadurationofatleast3minutes.
Theiconforthebattery,ancillaryorstarterbatteryinquestion
appearsinthemenu.
The message can be acknowledged; the battery should be
chargedimmediately.