32 Commissioning
10. Place the tube in such a way that it does not exert any strain on the mask when
you lie down.
11.
Now breath deeply and calmly, just through your nose. If the soft start function
(Ramp) has been selected (see page 63), the device reduces air pressure after
the mask test has been performed. It then increases pressure automatically gradu-
ally up to the prescribed value while you can go to sleep under reduced pressure.
Please note: Read how you can adapt the time settings for mask test and ramp to suit
your personal requirements in section „Description of parameters“ (starting page 51).
Turning on and off in battery mode
If the device is powered by the optional available powerpackpoint 2 , press and hold
the ON/OFF key for approx. 3 seconds to switch it on or off.
Please note: In standby mode the device automatically switches itself off after 1 minute.
Standby mode
If the blower is switched off, the device switches to standby mode (discernible on the
lit display with date and time).
The point 2 can be kept in standby mode permanently. This does not harm it.
If the powerpackpoint 2 is fitted on the device, the batteries are charged in standby
mode. The charging process is indicated by a flashing battery symbol on the display.
To Next Page
Loading...
