Hofmann ATC 900 - Page 60

CTC-CEN Service Manual 07-13 Rev.E
60
 Open completely the cylinder
 Disconnect the air pressure and the power supply.
 Remove the self locking nut of the stabilizer bar.
 Remove the ring nut from the wheel holder.
 Remove the wheel holder.
 Remove the screw from lift arm to disconnect the cylinder.
 Disconnect the air pipes from the cylinder.
 Remove the bolt from the to disconnect the cylinder from its
cabinet.
 Secure the cylinder to the cabinet with the bolt.
 Connect the air pipes.
 Fix the piston rod to the lift arm.
 Mount the wheel holder: the ring nut and the nut must be tightened until end of stroke and turned 1/8 of a turn
backward.
 Plug the machine to the air pressure and to power supply.
 Check if the machine works fine.