6 of 20
Install Batteries:
1. Unscrew the battery door at bottom of
unit and insert the batteries according
to the +/- polarity indicated.
2. Screw the battery door compartment on tightly.
Ensure the water tight o-ring is properly
aligned in place to ensure water resistance.
The red LED will begin flashing every 12 seconds.
Assembly of Stand and Pole:
Positioning: Install the 5-in-1 Wireless Outdoor Sensor in an
open location with no obstructions above and around the sensor
for accurate rain and wind measurement. Install the sensor with
the smaller end facing the South to properly orient the wind
direction vane. Secure the mounting stand and bracket (included)
to a post or pole, and allow minimum 1.5m off the ground.
Installation and Setup
5-in-1 Wireless Outdoor Sensor
1. Insert the top side
of the pole to the
square hole of the
weather sensor.
Ensure the pole
and sensor's
indicator align.
2. Place the nut in the
hexagon hole on the
sensor, then insert
the screw in other
side and tighten it
with a screw driver.
3. Insert the other
side of the pole to
the square hole of
the plastic stand.
Ensure the pole and
stand indicator align.
4. Place the nut in
the hexagon hole
of the stand, then
insert the screw
in other side and
then tighten it with
a screw driver.
To Next Page
Loading...
