18 of 20
Servicing
Servicing your Controller
The controller should always be serviced by an authorised agent. Follow these steps to return your unit:
1. Turn the mains power off to the controller
If the controller is hard-wired, a qualified electrician will be required to remove the entire unit, depending on the fault
2. Proceed to either unplug and return the entire controller with transformer or
disconnect the panel assembly only for servicing or repair
3. Disconnect the 24VAC leads at the controller 24VAC terminals on the very left hand side of the terminal block
4. Clearly mark or identify all valve wires according to the terminals they are connected to, (1–9)
This allows you to easily wire them back to the controller, maintaining your valve watering scheme
5. Disconnect valve wires from the terminal block
6. Remove the complete panel from the controller housing by unscrewing the two screws
in the lower corners of the fascia (both ends of the terminal block)
7. Remove the complete controller from the wall unplugging the lead
8. Carefully wrap the panel or controller in protective wrapping and pack in a
suitable box and return to your service agent or the manufacturer
Tampering with the unit will void the warranty.
9. Replace your controller panel by reversing this procedure.
The controller should always be serviced by an authorised agent
PRO469 Manual 2021 v1.indd 18PRO469 Manual 2021 v1.indd 18 15/1/21 9:40 am15/1/21 9:40 am
To Next Page
Loading...
Need help?
General
