3 of 20
Introduction
Your PRO469 Multi-Program Irrigation Controller
is available in 6 and 9 station configurations.
Designed to cover a wide range of applications
from residential and commercial turf, to light
agriculture, and professional nursery.
This controller has a possible 3 separate programs
with up to 12 starts per day. The controller has a 7 day
watering schedule with individual day selection per
program or a 365 calendar for odd/even day watering
or selectable interval watering schedules from every day
to every 15th day. Individual stations can be allocated to
one or all programs and can have a run time of 1 minute
to 12 hours 59 minutes or 25 hours if the water budget
is set to 200%. Now with “Water Smart Seasonal Set”
which allows the automatic run times to be adjusted
in percentage from “OFF” to 200% per month.
We have always been concerned with sustainable
water usage. The controller has many water saving
features that can be used to maintain the highest
standard of plant quality with the least amount of water
consumption. The integrated budget facility allows global
changes of run times without affecting programmed
run times. This allows for decreasing total water
consumption on days of minimal evaporation.
Correct Power-up Procedure
1. Connect to AC Power
2. Install a 9V battery to increase
the life of the coin battery
Batteries will maintain the clock
Features
L 6 and 9 station models
L Toroidal high capacity transformer
rated to 1.25AMP (30VA)
L Outdoor model with an inbuilt transformer
includes lead and plug, for Australia
L 3 programs, each of which has 4 start times,
maximum of 12 start times per day
L Station run times from 1 minute to
12 hours and 59 minutes
L Selectable watering options: Individual 7 day
selection, Even, Odd, Odd -31, interval watering
day selection from every day to every 15th day
L Watering budgeting feature allows quick
adjustment of the station run times by
percentage, from OFF to 200%, by month
L Rain sensor input will turn off all stations or selected
stations during wet periods, if a sensor is installed
L Permanent memory feature will retain
automatic programs during power failures
L Manual functions: run a program or group of
programs once, run a single station, with a test
cycle for all stations, OFF position to stop a watering
cycle or to stop automatic programs during winter
L Pump output to drive a 24VAC coil
L Real-time clock backed up with 3V
Lithium battery (pre-fitted)
L Contractor recall feature
PRO469 Manual 2021 v1.indd 3PRO469 Manual 2021 v1.indd 3 15/1/21 9:40 am15/1/21 9:40 am
To Next Page
Loading...
Need help?
General
