7 of 20
Programming (continued)
Set Run Times
This is the length of time that each station (valve)
is scheduled to water on a particular program
Maximum watering time is 12 hours
59 minutes for each station
A station can be assigned to any or
all of the possible 3 programs
1. Turn the dial to RUN TIMES
STATION No. 1 will be flashing labelled
as OFF, as shown above, meaning it has
no RUN TIME programmed in it
L The controller has permanent memory so
when there is a power failure, even if the
battery is not installed, the programmed
values will be restored to the unit
2. Press or to select the station (valve) number
3. Press and OFF will flash
4. Press or to adjust the RUNTIME
minutes as desired
5. Press and the RUNTIME hours will flash
6. Press or to adjust the
RUNTIME hours as desired
7. Press and the STATION No. will flash again
8. Press or to select another station (valve),
and repeat steps 2-7 above to set a RUN TIME
To turn a station OFF, set both the
hours and minutes to 0, and the display
will flash OFF as shown above
L This completes the setup procedure for PROG No. 1
Set Additional Programs
Set schedules for up to 6 PROGRAMS
by pressing when setting up START
TIMES, WATERINGDAYS and RUN
TIMES as previously outlined
L Although the controller will run automatic
programs with the MAIN DIAL in any position
(with the exception of OFF), we recommend to
leaving the main dial on AUTO position when
not programming or running manually
PRO469 Manual 2021 v1.indd 7PRO469 Manual 2021 v1.indd 7 15/1/21 9:40 am15/1/21 9:40 am
To Next Page
Loading...
