Holman PRO469 User Manual

8 of 20
Manual Operation
Run a Single Station
 The maximum run time is 12hours59minutes
1. Turn the dial to RUN STATION
 STATION No. 1 will be flashing
 The default manual run time is 10minutes–to edit
this, see Edit the Default Manual Run Time below
2. Use or to select the desired station
 The selected station will start running and
the RUNTIME will decrease accordingly
 If there is a pump or master valve connected,
PUMP A will be shown in the display,
indicating the pump/master is active
3. Press and the RUN TIME minutes will flash
4. Use or to adjust the minutes
5. Press and the RUN TIME hours will flash
6. Use or to adjust the hours
 The unit will revert to AUTO after the time has lapsed
L If you forget to turn the dial back to AUTO,
the controller will still run programs
7. To stop watering immediately, turn the dial to OFF
Edit the Default Manual Run Time
1. Turn the dial to RUN STATION
 STATION No. 1 will flash
2. Press and the RUN TIME minutes will flash
3. Use or to adjust the RUN TIME minutes
4. Press and the default RUN TIME hours will flash
5. Use or to adjust the RUN TIME hours
6. Once the desired RUN TIME is set, press to
save this as the default manual RUN TIME
L The new default will now always appear
when the dial is turned to RUN STATION
Run a Program
1. To manually run a complete program
or to stack multiple programs to run,
turn the dial to RUN PROGRAM
 OFF will flash on the display
2. To enable a PROGRAM, press and
the display will change to ON
 If no RUN TIME has been set for the desired
PROGRAM, the above step will not work
3. To run the desired PROGRAM immediately, press
Stacking Programs
L There may be times when it is desirable to
run more than one program manually
L The controller allows this to occur using its unique
facility of enabling a program, before running it
L For example, to run PROG No. 1 and also
PROGNo. 2, the controller will manage stacking
of the programs so they do not overlap
1. Follow steps 1 and 2 of Run a Program
to enable a single PROGRAM
2. To select the next PROGRAM press P
3. Enable the next PROGRAM by pressing
 To disable a program number, press
4. Repeat steps 2-3 above to enable
additional PROGRAMS
5. Once all desired PROGRAMS have been
enabled, they can be run by pressing
L The controller will now run all PROGRAMS
that have been enabled in sequential order
L This method can be used to enable any, or all
of the available programs on the controller.
 When running programs in this mode the
BUDGET% will alter the RUNTIMES of
each individual station accordingly
PRO469 Manual 2021 v1.indd 8PRO469 Manual 2021 v1.indd 8 15/1/21 9:40 am15/1/21 9:40 am

Holman PRO469 Specifications

General

Brand	Holman
Model	PRO469
Category	Controller
Language	English