To Next Page
D
dkruegerAug 13, 2025
What to do if Holux GPS RCV-3000 can not be found?
- MmontoyakevinAug 13, 2025
If you can't find the Holux RCV-3000, the Bluetooth connection may be poor. Try restarting your PC or notebook and reconnecting the device.
What to do if Holux GPS RCV-3000 can not be found?
If you can't find the Holux RCV-3000, the Bluetooth connection may be poor. Try restarting your PC or notebook and reconnecting the device.
What to do if the Holux GPS COM port can not be opened?
If you can't open the COM port on your Holux GPS device, it's possible that the Bluetooth connection has been interrupted, or the COM port is being used by another program. Check the Bluetooth connection again. Also, check for and close any other programs that might be conflicting with the COM port.
What to do if Holux GPS execute fails?
If the Holux GPS execute fails, it might be caused by an unstable Bluetooth function. Try turning the RCV-3000 off and on again. Also, restart your PC or notebook and reconnect the device.
What to do if my Holux GPS has no GPS output but the timer is running?
If your Holux GPS timer is counting but there's no GPS output, it could be due to a weak or nonexistent GPS signal where the RCV-3000 is located. Try testing it in an open area with a clear view of the sky and then restart the device. Also, if the device hasn't been used for a while, the ephemeris and almanac data in the GPS memory might be outdated. Remove the battery for 3 seconds, re-insert it, and power the device on again to test.
What to do if Holux RCV-3000 GPS has no GPS output but GPS timer is counting?
If your Holux GPS timer is running but there's no GPS output, it could be due to a weak or absent GPS signal. Try testing it in an open area and use the “Cold start” function in Mini GPS Viewer. Another reason might be outdated ephemeris and almanac data. To resolve this, remove the battery for 3 seconds, re-insert it, and power it on again to test.
What to do if Holux RCV-3000 can not open the COM port?
If you can't open the COM port on your Holux GPS, the Bluetooth connection might be interrupted, or the COM port is being used by another program. Check the Bluetooth connection and close any other programs that might be conflicting with the COM port.
What to do if Holux RCV-3000 GPS execute fail?
If your Holux GPS fails to execute, it might be due to an unstable Bluetooth function. Try turning the RCV-3000 on and off. Also, restart your PDA or PC and reconnect, referring to the “Bluetooth device connection installation” instructions.
Why Holux GPS can not find RCV-3000?
If your Holux GPS can't find the RCV-3000, the Bluetooth connection might be poor. Restart your PDA or PC and refer to the “Bluetooth device connection installation” instructions.
General| Interface | Bluetooth, USB |
|---|---|
| Operating Temperature | -10°C to +60°C |
| Chipset | SiRF Star III |
| Channels | 20 |
| Antenna | Built-in patch antenna |
| WAAS/EGNOS support | Yes |
| Update Rate | 1 Hz |
| Data Format | NMEA 0183 |
| Bluetooth Profile | SPP |
| Acquisition Sensitivity | -148 dBm |
| Tracking Sensitivity | -159 dBm |
| Humidity | 5% to 95% non-condensing |
| Battery | Rechargeable Li-ion battery |
| Memory | 4MB |
| Accuracy | 3 meters |
| Storage Temperature | -20°C to 70°C |
| Battery Life | 12 hours (continuous use) |
Warnings and guidelines for using the power adapter safely, including environmental conditions.
Cautionary notes regarding battery replacement, explosion risk, and proper disposal of used batteries.
Key points regarding warranty coverage, exclusions for damage, and limitations on HOLUX's responsibility.
Details of the GPS chipset, channels, receiver frequency, and onboard memory capacity.
Specifies reacquisition, cold start, warm start, and hot start times for GPS signal acquisition.
Outlines positional accuracy under different conditions, including WAAS/EGNOS enabled.
Defines operational limits for altitude, velocity, and acceleration for the device.
Details battery type, power consumption in different modes, and power saving features.
Covers output protocols like NMEA0183, data formats, datum, and interface types.
Describes Bluetooth SPP compatibility and the USB Type B connector for data and GPS signal.
Specifies device dimensions, weight, and operating/storage environmental conditions.
Details LED functions, Bluetooth frequency, sensitivity, and maximum output power.
Instructions for charging the device battery until the LED indicator turns off.
Guide to powering on the device and understanding Bluetooth status indicators and flow.
Explanation of GPS status indicators (orange LED) and satellite acquisition process.
Overview of the device's physical layout, LED indicators (GPS, Bluetooth, Battery), and their meanings.
Description of how to operate the device's power switch and its indicator light.
Table detailing the function of each pin in the Mini USB Type B power jack and data port.
Explanation of optional accessories and connector types, including the PC/Notebook USB port.
How the device logs data automatically upon powering on, and when logging stops.
Step-by-step guide for downloading and installing the ezTour software from the HOLUX website.
Instructions on how to launch the ezTour application after successful installation.
Guide for installing the necessary drivers for the RCV-3000 on your computer.
Steps to configure logging criteria, such as time or distance intervals, and device status.
Options for handling full data storage: overwrite data or terminate logging.
Addresses problems with no GPS output while the timer is counting, and possible solutions.
Solutions for execution failures, COM port issues, and device not found errors.
Explains FCC compliance, potential interference, and user actions to mitigate it.
Details on RF exposure compliance, installation, and operating conditions for FCC and CE.
Identifies the manufacturer, address, product description, and type designation.
States compliance with EU directives and lists applicable harmonized standards.
Lists permitted accessories, software, and hardware version details covered by the DoC.
