-17-
HEAD
10.5 GPS Searching
Place the drone on a flat and dry surface where is unobstructed and lit area.
When the indicator lights change from red to green, it means that the
search for GPS signal is completed. This process may take about one
minute.
If the search for GPS signal fails, please repeat all the Compass Calibration
operations until the process is successful.
ATTENTION:
① The default mode is the GPS Mode. It is highly recommended to
operate outdoor flights in GPS mode for maximum safety.
② If the GPS signal is weak or flying indoors, please short press the
Return to Home button to exit the GPS mode. At this time, the drone is
in Optical Flow Mode, and the maximum flying altitude does not
exceed 6m.
③ The drone will automatically changes to GPS mode when the GPS
signal is good. The operator can land and then take off again for a
higher altitude.
To Next Page
Loading...
